


work perfectly out of the box!
Great Game!
No issues to report here

it freezed in a couple of minutes every time I launched this game
it freezed in a couple of minutes every time I launched this game.

Works great
The game might crash if you select graphical options that will exceed your VRAM. But that happens on Windows as well. When you change graphical options on the fly, you might see some gameplay stuttering, but restarting the game fixes it.

Игра запустилась только если она установлена в стандартном хранилище (по стандартному пути). Если установить на другой диск, то не запустилась.
За время полного прохождения только 2 раза игра повисла.

It works out of the box
I need to set texture quality to 1024 pixels, TAA and FidelityFX for smooth performance.

Не запустилась
Works great on Linux like all the other titles in this series
We played local co-op with 1 keyboard/mouse and 2 controllers. Initially the game only detect a controller, so i disabled Steam Input Devices. But while the game detect all controller, some input button for a controller (player 2 or 3) also trigger input for keyboard (player 1) which limit what we can do as 3 players.
Game crashed once. Happened during local multiplayer when one player, using a controller, joined the game. Joining and leaving the game normally works; it only crashed this one time in 90 minutes of play. Not a significant issue.

Heavier than previous games and not many GFX settings exposed in-game, still runs and plays well with a bit of tinkering
Deck by default locked to 30 fps - open config file (check PCGW for location), change "OnBatteryFramerateLimit" to 60, change "OnBatteryRenderingQualityReductionEnabled" to false if you want
Low settings, Res Scale 0.8, TAA and FidelityFX Sharpening
Can try Allow Tearing and use in-game Vsync too

game crashed when I tried to change graphics quality to medium (instead of very high) and numerous times when trying to start the game past the main menu.
Game was pretty much unplayable due to performance issues. Also tried with Proton 8.0, the game simply crashed while loading.
Finished game without issues
It works as expected, no issues.

Works right out the box
No problems none whatsoever

Refresh rate 45hz and enabled v-sync in the game's options.
In some places (I remember The Thorny Hedge Maze) I couldn't get stable 60FPS with highest settings. There have been drops down to around 50FPS. When I set the refresh rate to 45HZ and enabled v-sync in the game's options I got stable 45FPS.
Just works
Played with gamepad/KB+M. The thumbstick controls are inverted from prior games :/
Works perfectly with Proton 7.0-4. No launch commands needed. Completely smooth play, and it looks great even at low settings.
Works well out of the box
Played the campaign to 100% in co-op mode. Only issue was that I did not get the achievement for completing the last level. Tried again, this time as the host, and it worked. But this bug might not be specific to linux.
The game runs perfectly out of the box! My Xbox Series controller works perfectly equally.
Works very well out of the box. The game runs at 60fps on "medium" graphics presets. It cannot maintain 60fps on "high" presets though (runs at 40-50fps). The Steam Deck native resolution is supported and detected by default.
On rare occasions, audio can stutter for a while after resuming. Only happened once so far.
Battery lasts about 4h
Completed the game, no issues

Too many graphical glitches on my configuration
Texture resolution is lower then normal but the major problem is the corruption of every magic effect and light
Funciona perfectamente.
Explicitly disable Steam input in game settings in Steam, otherwise controllers not always detected or detected as a wrong model (I have PS4 controllers).
On 4k screen had to set 1k textures, 0.5 resolution scale and medium antialiasing (TAA) for it not to lag. Any better settings make it barely playable.
GCPU Error

Had to change to proton 5.0-10
Do the laptop battery config ini change to get 60fps, otherwise it is limited to 30fps
very playable
some random times the game drop around 20 fps and back to normal when restarted, happened three times with me, i think it's because i was alt tabbing too much.
Stuck at starting animation

Runs perfectly out of the box
Returned after a year and a half to play the new "Melody of Mystery" DLC. Played about eight more hours without a single issue.
Works out of the box with Proton 5.13-5.
First I had some white shades issue, because it used Glorius Eggroll by default. But with regular Proton (5.13-5), it worked flawlessly.
Not playable at the moment, game just hangs after a few minutes
Video output hangs respectively moves approx 1 frame per minute
Multiplayer: Xbox One Controller (Wireless mode) always brings game to halt as soon as one leaves the initial house at the start. In Wired Mode, it works a few minutes longer.
After a few minutes video output hangs massively, audio output continues normally.

Have to edit options.txt to launch the game. Then get a frozen game in a couple of minutes. Unfortunately unplayable :(
Shadows flickering
Game crashes & freezes computer after 2 minutes of gameplay

GPU Error Detected: Failed to create texture resource
When I click "Play" on Steam, game loads into black full screen, with Wizard running on the bottom-right. Then gives this error. Booted into another distro and same results. For more info about the issue, see: https://steamcommunity.com/app/690640/discussions/0/3003304160976194983/