
Palex
Published
40FPS/40HZ cap
Controls work well on the Steam Deck, the only issue I had was it was difficult to summon and dismiss mounts. Singleplayer works really well, I didnt try local or online multiplayer.
40 fps and refresh rate cap
Inverting game pad controls does not work.
40fps and refresh rate cap. 720p with FSR and sharpening at 3
Runs great on the Steam Deck, controller support gives multiple different default configurations
Runs smooth with the recommended Steam Deck setting. Haven't noticed any performance issues after 10ish hours.
40fps and 40 refresh rate cap.
Requires touch controls.
Runs well and looks decent even though it's running at medium or low. I've got FSR with sharpening at 3 and res at 720p, with a 40fps and refresh rate cap. Haven't noticed any drops below 40fps so far.
It's much better played with a keyboard and mouse, the aiming with a controller is too imprecise. Not recommend on Steam Deck.
40fps and refresh rate cap
Aiming with a controller is very imprecise with the official layout or the custom gyro layouts.
Runs perfectly using proton experimental, but only shows PlayStation controller prompts on the Steam Deck.
Runs fine, although at 60fps it runs hot and spins the fans up. The game need to be installed on the internal drive in order to launch.
40 fps/hz cap
Windowed view was default and it didn't fit the screen. Able to easily change to full screen.
This game cannot be launched if it's installed on an SD card.
40fps cap
During "All Out Attacks" the game consistently drops to about 20fps.
There is a pretty consistent behavior where loading into a new area will cause the fans on the Steam Deck to spin up to an audible level for a second or two. While not a performance issue, some people may find it annoying.
With a 40fps and refresh rate cap the battery life is very good. Probably somewhere between 4-8 hours.
40hz and fps cap.
Launcher requires use of touch screen.
Does not seem to support steam deck controls, unable to do anything after getting into the main menu.
40fps and refresh rate cap. FSR enabled with sharpening set to 3.
You have to switch to controller controls manually in the setting with touch (on Steam Deck without a mouse) before starting a new game.
Controller is not detected and set to default automatically.